20 Comments

  1. Angel DeTierra on January 19, 2023 at 8:09 pm

    ► In the near future I will replace the lights of my house with LED lights. Thanks for the video. Now, I have a the know how!



  2. W C on January 19, 2023 at 8:11 pm

    nice quick video to demonstrate how to connect daisy chain LED lights. How many LED lights can you string together?



  3. I Z on January 19, 2023 at 8:12 pm

    Finalllyyy



  4. Jun Dancel on January 19, 2023 at 8:18 pm

    Is it ok for a multiple lights to connect in one switch? Similar to Christmas lights? And also is it ok if the multiple lights, I connected the source between the lights? Is it safe? Unlike the Christmas lights, u have it at the end and connect to the source. Thanks



  5. Paul Guilbeault on January 19, 2023 at 8:19 pm

    Good, simple video. I wired up 2 recessed LEDs like this recently. They work fine, they dim fine, but there is a delay between the first one coming on and the second, it’s a tiny delay but it is noticeable. What can be causing the issue?



  6. 29:11 on January 19, 2023 at 8:21 pm

    Perfect! Thank you!



  7. Co Lo on January 19, 2023 at 8:25 pm

    Prefect video short to the point! Thank you



  8. Daniel Groger on January 19, 2023 at 8:27 pm

    What wire size you use



  9. Fahad Otaif on January 19, 2023 at 8:29 pm

    Can it work with 220 volts?



  10. Alicia Zimmer on January 19, 2023 at 8:32 pm

    There was no green wire going from 1 light to the other!? You used 14/2 wire, meaning there was only 2 wires, black and white, and the ground going between the lights, yet you showed a green wire being plugged into the connector in the 1st light you wired. Where did that green wire go? Please explain…



  11. Hardik Rana on January 19, 2023 at 8:33 pm

    Need Help:
    i got a quick question. We have pre wiring for fan. Its the 14-3 wire. White, black, red and ground. The black wire has constant power, which i am using it to run the ceiling fan. I have to use remote to turn the fan/light on and off. I capped the red wire.

    The red wire is what control by the switch. My question is, can i use the red, white and ground to add some recessed light? Is it ok to do that? I am just worried because i am using the black to run the fan. Not sure if i can use the same neutral and ground for recessed lights which is already being used for the fan.



  12. Scott Yarwood on January 19, 2023 at 8:34 pm

    How do they communicate whether they are daisychained or connected as a series? I have two areas in my basement that I will be putting about eight in one and 10 in the other. I want the two areas to operate independently. How is one area communicating with the group and the other side communicating with themselves? Are they each individually loaded by the app into one group? Do they speak to each other? How is this done? Thank you



  13. Albert Pecoraro on January 19, 2023 at 8:46 pm

    Finally, a video that gets right to the point without all that yammering! 🙂



  14. TheAverageGuy on January 19, 2023 at 8:46 pm

    Would that set up be possible to connect in parallel?



  15. Tom Wu on January 19, 2023 at 8:48 pm

    Can only one Wifi Pairing for all lights? It is pain to manage 20 lights and sometime wifi signal delay causing inconsistant behaviour



  16. MrBecerraXXL on January 19, 2023 at 8:49 pm

    Thanks



  17. splenda89 on January 19, 2023 at 8:52 pm

    Thank you this is a great video. to the point, simple and easy to follow.



  18. S Gill on January 19, 2023 at 8:54 pm

    There was no green wire. And my lights flash on and off after being on for about 5 seconds. How do I stop this?



  19. Rudy Enter on January 19, 2023 at 8:57 pm

    Super! Was starting to wonder if nobody daisy-chained these lights. And… this from the manufacturer – Thanks!!!



  20. Dom Tam on January 19, 2023 at 8:58 pm

    What gauge wire is recommended for residential installation?